Ask C100 Manual de usuario descargar pdf (Pagina 6)

Extron • System 8/10 P

LUS

• User’s Manual • P/N 68-548-01 Rev. B

ASK Installation Configuration and Connections

Page 6

ASK C100 Projector Configuration

Verify that the System 8/10 PLUS is already configured for the ASK C100

projector. The general setup is explained on page 3-4 and the switch settings for

the projector are repeated below.

1. Use a small screwdriver to remove the access cover from the System 8/10 PLUS

front panel. See bottom of page 3-3. The label on the back of the access cover

also has the configuration information.

__________ Before changing anything, remove the AC power cord to the System 8/10 P

LUS

to verify that the main power is OFF; also turn the projector power OFF.

2. Set the switches as follows:

Config Model Rotary Switches Cable SW15 Settings Comm

as RS1 RS2 RS3 RS4 J2/J3 1 2 3 4 5 6 7 8 9 10 Adapter

ASK C100 0 0 E F J2 ↓↓ ↑ ↓ ↑↓ ↑ ↓

↑↓ 26-523-01

_RS5 is for RGB

switching delay. See

page 3-4 for more

information on switch

functions.

3. Use a grease pencil (or other rub-off marker) to mark the space on the label next

to “ASK C100”.

4. Locate the switcher’s Address DIP switches on the rear panel, lower right. Unless

this is part of a master/slave system, set #3 and #5 to the up position and the

others down. See illustration to the left.

Use the illustration on the following page to do the next steps.

5. Connect the Comm adapter’s DIN connector to the projector’s “Mouse 1” port.

6. Connect the CC-50' (or CC-100') communications extension cable from the 9-pin

male connector of the Comm Adapter to the 15-pin HD “Projector Control” port

located on the rear panel of the System 8/10 PLUS.

______ Secure the screws on all D connectors.

7. Connect the BNC (RGBS) cables from the System 8/10 PLUS outputs to the

projector’s 15-pin female “Analog Computer VGA” connector. For composite

video, connect the RCA connector from the System 8/10 Plus to the projector’s

“Video” connector. For S-Video, connect the DIN connector from the System 8/

10 Plus to the projector’s “S-Video” connector.

8. Apply Main Power to the System 8/10 PLUS by connecting the power cord. The

Main Power LED should light. Apply power to the projector.

Configured For:

RS-232

345678 9101

SW15 DIP Switch

RS5 RS2

RS2

RS1

RS3

RS4

RS1

RS3 RS4

1 2 3 4 5 6 7

Comentarios a estos manuales

Sin comentarios

Ask C100 Manual de usuario Pagina 6

Comentarios a estos manuales

Relacionado con productos y manuales para Proyectores Ask C100